28 - 12/97 - Butadiene Loadings - ex Brindisi (Italy)


We have been advised of several incidents where cargoes of Butadiene, ex Brindisi have been rejected at the intended discharge port due to excessive dimer content.

The dimerisation of butadiene is an unstoppable process, its rate being said to be purely under thermal control. Practically speaking, the rate of dimerisation can be held at an insignificant level if the temperature of the cargo can be held at a level below zero degrees Celsius.

Whilst gas ships are very good at maintaining cargo temperatures, they are sometimes required by the cargo suppliers (Enichem in Brindisi is one) to receive onboard, an initial warm quantity of cargo that has been residing in the shoreline for some considerable time.The vessel is required to cool the received cargo down, often to fully refrigerated temperatures (minus 5 degrees Celsius at atmospheric pressure) at the quickest rate possible to prevent further significant dimer formation.

At Brindisi the shoreline is several kilometers long and of course the summer ambient temperatures can be very high indeed. The shoreline contents, which amount to approximately 65 tonnes of butadiene, increases in dimer content to unknown concentrations and is loaded on board the vessel. Eventually cooler (semi refrigerated) cargo from shoretank storage reaches the vessel and the high dimer shoreline cargo is diluted with low dimer cargo from shore tank storage.

We understand that cargoes that are ostensibly on specification with respect to dimer content at Brindisi upon completion of loading, are sometimes found to be off specification after, say, a transit of the North Atlantic to the US.

Invariably where there has been a dimer problem on discharge the ship has been held fully responsible!

There is concern that the dimer content of the cargo bulk, upon completion of loading at Brindisi, has been understated in analysis conducted by Enichem due to the difficulty in obtaining representative samples immediately following admixture of the high and low dimer content portions of the cargo.Certainly very high dimer butadiene becomes more viscous and oilier as a result of its elevated dimer content and whilst in the long term it is completely  soluble in the cargo bulk, there is some concern that the loadport Certificates of Quality (used by claimants to establish a prima facie case) can, in some shipments, understate the real situation and that the cargo did not have enough allowance between shipment and receiving dimer specifications to successfully undertake the voyage.

In summary, we believe gas ship owners should be wary at Brindisi and any other ports where warm butadiene cargo is supplied. Masters should always note protest of the fact that warm cargo was initially supplied and diligently record a quantity/temperature record of the initial cargo. If the ship has a sample cylinder onboard we would recommend that a sample is taken at the liquid manifold upon commencement of loading (a first pumpings sample) and retained on board  in a deep freeze until it is apparent that all is well at the discharge port. This sample will be invaluable in the event of "off specification" dimer content being declared at discharge port. Alternatively if no sample cylinder is available onboard owners might consider instructing a local surveyor to draw and retain this sample on their behalf.

 

For further information please contact David Jones of CWA Consultants 

Tel :-  +44 171 242 8444

Fax:-  +44 171 242 7555 

Source of information: 

David Jones CWA Consultants  through K.S.Lumbers

Industry developments

Polar Shipping

Legal, navigational and environmental resources, news and updates on the development of polar shipping. Read more


US VRP Compliance

With effect from 30th January 2014 non-tank as well as tankships calling at US ports will be required to submit VRPs.  For Club and other resources to assist in compliance click here


International Environmental compliance

Environmental Compliance resource page collates material in respect of International environmental compliance issues affecting our Members. Information from the Club, Loss Prevention and external resources has been collated in one place for ease of reference.


MLC 2006

The Maritime Labour Convention enters into force in August 2013 - resources, news & advice on implementation can be found in this dedicated section.  READ MORE


International sanctions

Recent guidance & corresponding material in respect of international sanctions against various countries has been updated with respect to temporary easing of sanctions against Iran.  READ MORE


Piracy

Essential precautions and preparation against piracy, as well as additional information and resources, loss prevention advisories and useful external web links


Emergency Contacts


If you need to call our offices out of hours and at weekends, click After Office hours for a up to date list of the names of the Duty Executives and their mobile phone numbers. 

Ship Finder


This Ship Finder is updated on a daily basis. Members who need to advise the Club of updates to their recorded ships' details should advise their usual underwriting contact.