- Insurance Cover
- Knowledge & Publications
- Loss Prevention
- About Us
International Convention for the Control and Management of Ships' Ballast Water and Sediments
The Convention is divided into Articles; and an Annex which includes technical standards and requirements in the Regulations for the control and management of ships' ballast water and sediments.
The main features of the Convention are outlined below.
Entry into force
Parties are given the right to take, individually or jointly with other Parties, more stringent measures with respect to the prevention, reduction or elimination of the transfer of harmful aquatic organisms and pathogens through the control and management of ships' ballast water and sediments, consistent with international law. Parties should ensure that ballast water management practices do not cause greater harm than they prevent to their environment, human health, property or resources, or those of other States.
Research and monitoring
Survey, certification and inspection
All possible efforts shall be made to avoid a ship being unduly detained or delayed (Article 12 Undue Delay to Ships).
Annex - Section A General Provisions
Annex - Section B Management and Control Requirements for Ships
Ships must have a Ballast Water Record Book (Regulation B-2) to record when ballast water is taken on board; circulated or treated for Ballast Water Management purposes; and discharged into the sea. It should also record when Ballast Water is discharged to a reception facility and accidental or other exceptional discharges of Ballast Water
The specific requirements for ballast water management are contained in regulation B-3 Ballast Water Management for Ships:
Ships constructed before 2009 with a ballast water capacity of between 1500 and 5000 cubic metres must conduct ballast water management that at least meets the ballast water exchange standards or the ballast water performance standards until 2014, after which time it shall at least meet the ballast water performance standard.
Ships constructed before 2009 with a ballast water capacity of less than 1500 or greater than 5000 cubic metres must conduct ballast water management that at least meets the ballast water exchange standards or the ballast water performance standards until 2016, after which time it shall at least meet the ballast water performance standard.
Ships constructed in or after 2009 with a ballast water capacity of less than 5000 cubic metres must conduct ballast water management that at least meets the ballast water performance standard.
Ships constructed in or after 2009 but before 2012, with a ballast water capacity of 5000 cubic metres or more shall conduct ballast water management that at least meets the standard described in regulation D-1 or D-2 until 2016 and at least the ballast water performance standard after 2016.
Ships constructed in or after 2012, with a ballast water capacity of 5000 cubic metres or more shall conduct ballast water management that at least meets the ballast water performance standard.
Other methods of ballast water management may also be accepted as alternatives to the ballast water exchange standard and ballast water performance standard, provided that such methods ensure at least the same level of protection to the environment, human health, property or resources, and are approved in principle by IMO's Marine Environment Protection Committee (MEPC).
Under Regulation B-4 Ballast Water Exchange, all ships using ballast water exchange should:
whenever possible, conduct ballast water exchange at least 200 nautical miles from the nearest land and in water at least 200 metres in depth, taking into account Guidelines developed by IMO;
in cases where the ship is unable to conduct ballast water exchange as above, this should be as far from the nearest land as possible, and in all cases at least 50 nautical miles from the nearest land and in water at least 200 metres in depth.
When these requirements cannot be met areas may be designated where ships can conduct ballast water exchange. All ships shall remove and dispose of sediments from spaces designated to carry ballast water in accordance with the provisions of the ships' ballast water management plan (Regulation B-4).
Annex - Section C Additional measures
Annex - Section D Standards for Ballast Water Management
Regulation D-1 Ballast Water Exchange Standard
Regulation D-2 Ballast Water Performance Standard
The indicator microbes, as a human health standard, include, but are not be limited to:
a. Toxicogenic Vibrio cholerae (O1 and O139) with less than 1 colony forming unit (cfu) per 100 milliliters or less than 1 cfu per 1 gram (wet weight) zooplankton samples ;
b. Escherichia coli less than 250 cfu per 100 milliliters;
c. Intestinal Enterococci less than 100 cfu per 100 milliliters.
Ballast Water Management systems must be approved by the Administration in accordance with IMO Guidelines (Regulation D-3 Approval requirements for Ballast Water Management systems). These include systems which make use of chemicals or biocides; make use of organisms or biological mechanisms; or which alter the chemical or physical characteristics of the Ballast Water.
Review of standards
Annex- Section E Survey and Certification Requirements for Ballast Water Management
Resolutions adopted by the Conference
Conference resolution 1: Future work by the Organization pertaining to the International Convention for the Control and Management of Ships' Ballast Water and Sediments
Conference resolution 2: The use of decision-making tools when reviewing the standards pursuant to Regulation D-5
Conference resolution 3: Promotion of technical co-operation and assistance
Conference resolution 4: Review of the Annex to the International Convention for the Control and Management of Ships' Ballast Water and Sediments
The problem of invasive species is largely due to the expanded trade and traffic volume over the last few decades. The effects in many areas of the world have been devastating. Quantitative data show the rate of bio-invasions is continuing to increase at an alarming rate, in many cases exponentially, and new areas are being invaded all the time. Volumes of seaborne trade continue overall to increase and the problem may not yet have reached its peak.
Specific examples include the introduction of the European zebra mussel (Dreissena polymorpha) in the Great Lakes between Canada and the United States, resulting in expenses of billions of dollars for pollution control and cleaning of fouled underwater structures and waterpipes; and the introduction of the American comb jelly (Mnemiopsis leidyi) to the Black and Azov Seas, causing the near extinction of anchovy and sprat fisheries.
The problem of harmful aquatic organisms in ballast water was first raised at IMO in 1988 and since then IMO's Marine Environment Protection Committee (MEPC), together with the Maritime Safety Committee (MSC) and technical sub-committees, have been dealing with the issue, focusing in the past decade first on guidelines and then on developing the new convention.
Going further into history, scientists first recognized the signs of an alien species introduction after a mass occurrence of the Asian phytoplankton algae Odontella (Biddulphia sinensis) in the North Sea in 1903.
But it was not until the 1970s that the scientific community began reviewing the problem in detail. In the late 1980s, Canada and Australia were among countries experiencing particular problems with unwanted species, and they brought their concerns to the attention of IMO's Marine Environment Protection Committee (MEPC).
In 1991 the MEPC adopted MEPC resolution 50(31) - Guidelines for Preventing the Introduction of Unwanted Organisms and Pathogens from Ships' Ballast Water and Sediment Discharges; while the United Nations Conference on Environment and Development (UNCED), held in Rio de Janeiro in 1992, recognized the issue as a major international concern.
In November 1993, the IMO Assembly adopted resolution A.774(18) - Guidelines for Preventing the Introduction of Unwanted Organisms and Pathogens from Ships' Ballast Water and Sediment Discharges, based on the Guidelines adopted in 1991. The resolution requested the MEPC and the MSC to keep the Guidelines under review with a view to developing internationally applicable, legally-binding provisions.
The 20th Assembly of IMO in November 1997 adopted resolution A.868(20) - Guidelines for the control and management of ships' ballast water to minimize the transfer of harmful aquatic organisms and pathogens.
The development of the draft mandatory instrument has been continuing since then until this week's adoption of the new instrument.
Some examples of aquatic bio-invasions causing major impact are listed in the table, but there are hundreds of other serious invasions which have been recorded around the world:
The Conference also adopted four resolutions: Gives requirements for initial renewal, annual, intermediate and renewal surveys and certification requirements. Appendices give form of Ballast Water Management Certificate and Form of Ballast Water Record Book. Under regulation D-5 Review of Standards by the Organization, IMO is required to review the Ballast Water Performance Standard, taking into account a number of criteria including safety considerations; environmental acceptability, i.e., not causing more or greater environmental impacts than it solves; practicability, i.e., compatibility with ship design and operations; cost effectiveness; and biological effectiveness in terms of removing, or otherwise rendering inactive harmful aquatic organisms and pathogens in ballast water. The review should include a determination of whether appropriate technologies are available to achieve the standard, an assessment of the above mentioned criteria, and an assessment of the socio-economic effect(s) specifically in relation to the developmental needs of developing countries, particularly small island developing States.Regulation D-4 covers Prototype Ballast Water Treatment Technologies. It allows for ships participating in a programme approved by the Administration to test and evaluate promising Ballast Water treatment technologies to have a leeway of five years before having to comply with the requirements. - Ships conducting ballast water management shall discharge less than 10 viable organisms per cubic metre greater than or equal to 50 micrometres in minimum dimension and less than 10 viable organisms per milliliter less than 50 micrometres in minimum dimension and greater than or equal to 10 micrometres in minimum dimension; and discharge of the indicator microbes shall not exceed the specified concentrations. - Ships performing Ballast Water exchange shall do so with an efficiency of 95 per cent volumetric exchange of Ballast Water. For ships exchanging ballast water by the pumping-through method, pumping through three times the volume of each ballast water tank shall be considered to meet the standard described. Pumping through less than three times the volume may be accepted provided the ship can demonstrate that at least 95 percent volumetric exchange is met.There is a ballast water exchange standard and a ballast water performance standard. Ballast water exchange could be used to meet the performance standard:A Party, individually or jointly with other Parties, may impose on ships additional measures to prevent, reduce, or eliminate the transfer of Harmful Aquatic Organisms and Pathogens through ships' Ballast Water and Sediments. In these cases, the Party or Parties should consult with adjoining or nearby States that may be affected by such standards or requirements and should communicate their intention to establish additional measure(s) to the Organization at least 6 months, except in emergency or epidemic situations, prior to the projected date of implementation of the measure(s). When appropriate, Parties will have to obtain the approval of IMO.Ships are required to have on board and implement a Ballast Water Management Plan approved by the Administration (Regulation B-1). The Ballast Water Management Plan is specific to each ship and includes a detailed description of the actions to be taken to implement the Ballast Water Management requirements and supplemental Ballast Water Management practices. This includes definitions, application and exemptions. Under Regulation A-2 General Applicability: "Except where expressly provided otherwise, the discharge of Ballast Water shall only be conducted through Ballast Water Management, in accordance with the provisions of this Annex."Under Article 13 Technical Assistance, Co-operation and Regional Co-operation, Parties undertake, directly or through the Organization and other international bodies, as appropriate, in respect of the control and management of ships' ballast water and sediments, to provide support for those Parties which request technical assistance to train personnel; to ensure the availability of relevant technology, equipment and facilities; to initiate joint research and development programmes; and to undertake other action aimed at the effective implementation of this Convention and of guidance developed by the Organization related thereto.Ships are required to be surveyed and certified (Article 7 Survey and certification) and may be inspected by port State control officers (Article 9 Inspection of Ships) who can verify that the ship has a valid certificate; inspect the Ballast Water Record Book; and/or sample the ballast water. If there are concerns, then a detailed inspection may be carried out and "the Party carrying out the inspection shall take such steps as will ensure that the ship shall not discharge Ballast Water until it can do so without presenting a threat of harm to the environment, human health, property or resources."Article 6 Scientific and Technical Research and Monitoring calls for Parties individually or jointly to promote and facilitate scientific and technical research on ballast water management; and monitor the effects of ballast water management in waters under their jurisdiction.Under Article 5 Sediment Reception Facilities Parties undertake to ensure that ports and terminals where cleaning or repair of ballast tanks occurs, have adequate reception facilities for the reception of sediments. The Convention will enter into force 12 months after ratification by 30 States, representing 35 per cent of world merchant shipping tonnage (Article 18 Entry into force).General ObligationsUnder Article 2 General Obligations Parties undertake to give full and complete effect to the provisions of the Convention and the Annex in order to prevent, minimize and ultimately eliminate the transfer of harmful aquatic organisms and pathogens through the control and management of ships' ballast water and sediments.